Как программно уменьшить пинг?

[reisereise_A]

Ну и где ету самую прогу мона взять ?

[4p_Wik]

Это стандартная утилита винды:}
пуск->выполнить-> ping

ping [-t] [-a] [-n Count] [-l Size] [-f] [-i TTL] [-v TOS] [-r Count] [-s Count] [{-j HostList | -k HostList}] [-w Timeout] [TargetName]

Parameters
-t
Specifies that ping continue sending Echo Request messages to the destination until interrupted. To interrupt and display statistics, press CTRL-BREAK. To interrupt and quit ping, press CTRL-C.
-a
Specifies that reverse name resolution is performed on the destination IP address. If this is successful, ping displays the corresponding host name.
-n Count
Specifies the number of Echo Request messages sent. The default is 4.
-l Size
Specifies the length, in bytes, of the Data field in the Echo Request messages sent. The default is 32. The maximum size is 65,527.
-f
Specifies that Echo Request messages are sent with the Don't Fragment flag in the IP header set to 1. The Echo Request message cannot be fragmented by routers in the path to the destination. This parameter is useful for troubleshooting path Maximum Transmission Unit (PMTU) problems.
-i TTL
Specifies the value of the TTL field in the IP header for Echo Request messages sent. The default is the default TTL value for the host. For Windows XP hosts, this is typically 128. The maximum TTL is 255.
-v TOS
Specifies the value of the Type of Service (TOS) field in the IP header for Echo Request messages sent. The default is 0. TOS is specified as a decimal value from 0 to 255.
-r Count
Specifies that the Record Route option in the IP header is used to record the path taken by the Echo Request message and corresponding Echo Reply message. Each hop in the path uses an entry in the Record Route option. If possible, specify a Count that is equal to or greater than the number of hops between the source and destination. The Count must be a minimum of 1 and a maximum of 9.
-s Count
Specifies that the Internet Timestamp option in the IP header is used to record the time of arrival for the Echo Request message and corresponding Echo Reply message for each hop. The Count must be a minimum of 1 and a maximum of 4.
-j HostList
Specifies that the Echo Request messages use the Loose Source Route option in the IP header with the set of intermediate destinations specified in HostList. With loose source routing, successive intermediate destinations can be separated by one or multiple routers. The maximum number of addresses or names in the host list is 9. The host list is a series of IP addresses (in dotted decimal notation) separated by spaces.
-k HostList
Specifies that the Echo Request messages use the Strict Source Route option in the IP header with the set of intermediate destinations specified in HostList. With strict source routing, the next intermediate destination must be directly reachable (it must be a neighbor on an interface of the router). The maximum number of addresses or names in the host list is 9. The host list is a series of IP addresses (in dotted decimal notation) separated by spaces.
-w Timeout
Specifies the amount of time, in milliseconds, to wait for the Echo Reply message that corresponds to a given Echo Request message to be received. If the Echo Reply message is not received within the time-out, the "Request timed out" error message is displayed. The default time-out is 4000 (4 seconds).
TargetName
Specifies the destination, which is identified either by IP address or host name.

[amo]

4p_Wik
Подскажи пожалуйста (или дай ссылку) типичные настройки реестра и модема для D2.
И еще, как оставить окно утилиты ping на экране (оно стразу закрывается) ?

[DEathkNIghtS]

-t
Specifies that ping continue sending Echo Request messages to the destination until interrupted. To interrupt and display statistics, press CTRL-BREAK. To interrupt and quit ping, press CTRL-C.

[4p_Wik]

Подскажи пожалуйста (или дай ссылку) типичные настройки реестра и модема для D2.

MTUSpeed410ru.exe например. Это про реестр.
А насчет модема... установи максимальную скорость коннекта на 19kbps. Для Д2 вполне хватает,правда на ПвП 8 ппл будет подлагивать.

[573-й]

постоянно страдаю от пинга 260, немного помогло использование флагов -npl -ns -lg, то ли с ними трафик меньше толи ещё что но лагов стало меньше.

[amo]

4p_Wik

А насчет модема... установи максимальную скорость коннекта на 19kbps. Для Д2 вполне хватает,правда на ПвП 8 ппл будет подлагивать.

Спасибо за ответ. При 19kbps коннект будет стабильнее, чем при ~50kbps?

[DEathkNIghtS]

При более низкой скорости коннекта на плохих линиях качество заметно улучшается. Поэкспериментируй.